ARLA/CLUSTER: Kenwood TMD 700

[ct2jnm sapo.pt]

Obrigado aos colegas
Se alguma coisa de pior acontecer (espero que não) darei noticias para  
que não façam o mesmo

Cordiais cumprimentos
CT2JNM - Nuno Fonseca


Quoting Rodrigo <ct1bxt  hotmail.com>:

> boas,
>
>
> Aqui vai:
>
> Thanks to KD4CWB for the basis for this modification
>
> To modify the transmitter to cover 142 - 151.995 Mhz and 420-449.995  
> Mhz, perform the following steps:
> MOST IMPORTANT - this mod will do a reset on your radio and erase  
> ALL of your settings (memory, APRS, menus, etc.). Use the computer  
> program to pull all of the settings out BEFORE you go any further.  
> Or if no computer, a very large tablet. This radio has many many  
> programable features.
>
> Turn off the radio and disconnect the power
>
> Remove the five screws from bottom cover (not the side with the speaker).
>
> Remove the bottom cover. It may take a little prying with a small  
> screwdriver.
>
> REMEMBER if you haven't saved your settings, all will be lost if you  
> proceed beyond this point.
>
> Cut ONLY the famous Kenwood green wire, located near the voice  
> synthesizer board connector. The green wire ties two PC board lands  
> together and is about 1/2" long. Make sure the ends can't short  
> against anything.
>
> Reinstall the bottom cover.
>
> Reapply power and turn the radio on (it will automatically reset).
>
> Use the computer program to reinstall all of your operating  
> parameters. I found that the load ALL function did not seem to do  
> everything. Try the load MEMORY and MENU selections too. Or prepare  
> to spend a whole bunch of time re-entering all of your parameters  
> that you wrote down in step 1.
>
>
>
> 73
> Rodrigo
> ct1bxt
>
>
>
>
>
> Em Sat, 18 May 2013 23:59:53 +0100, <ct2jnm  sapo.pt> escreveu:
>
>>
>> Procuro ajuda.
>>
>> Tenho um Kenwood TMD700. Em VHF faz TX de 144 a 146. Ora Preciso de
>> trabalhar com ele numa frequência privada (de uma empresa de eventos
>> aqui da zona) na faixa dos 152.000 MHz.
>>
>> Há algum colega que saiba se é possível abrir o TX deste equipamento
>> para abranger aquela frequência?
>> Já procurei na net e não encontrei nada sobre o assunto, pois se é
>> possível não sei se será através de algum menu ouse tenha que
>> desmanchar o equipamento e fazer alguma alteração.
>>
>> Bem haja a todos.
>> 73
>> CT2JNM - Nuno Fonseca
>>
>
>
> --